Remote Transmitter / Transceiver Programming (1-Way & 2-Way Remotes) - CrimeStopper CS-2011RS IV Installation Handbook

before cranking. This option is helpful if you are unable to locate a glow plug signal. Just select a delay time and do
not connect the Pink Glow Plug wire. Selections: 10, 20, 30 seconds, or Monitor Pink Wire (Default).
23. REMOTE START ENGINE RUN TIME: Set engine run time for 12, 24, 36 or 48 minutes as desired.
24. ULTRA-SMART TACHLESS VOLTAGE ADJUSTMENT:
This option controls the voltage reference point when using smart Tachless mode. Pressing the Lock or Unlock
buttons on the remote raises or lowers the reference level in 1% increments from 80%-%100. Button #3 resets the
unit to the factory default reference point of 93%. The default 93% setting works for most vehicles. See page 14 for
additional Ultra-Smart Tachless mode information.
25. FACTORY HORN CHIRPS / PULSES:
This option controls the system's horn honk output. There are 3 selections:
4 Button 1 (Lock): Pulses with trip
4 Button 2 (Unlock): Arm/Disarm chirp and pulse with trip
4 Button 3 (Trunk Pop): Arm/Disarm warning chirp and pulse with trip (default)
PROGRAMMING – TRANSCEIVERS & TRANSMITTERS
MAKE a NOTE of the following transmitter / transceiver compatibilities:
CS-2011RS Series IV 1-WAY SYSTEM: CS-411TX Remotes ONLY
CS-2012TW1 2-Way System: CS-799LED Remote / CS-419TW "Sidekick" non-paging remote
CS-2014TW2 2-Way System: CS-599FM LCD Remote / CS-416TW "Sidekick" non-paging remote
CS-2016FM 2-Way System: CS-699FM LCD Remote / CS-397TW "Sidekick" non-paging remote
Use the part numbers referenced above when ordering remotes. Some remotes are NOT interchangeable between systems.
When re-learning remotes or adding remotes, ALL your system's remotes must be learned at time of programming! These
systems allow storage of up to 4 different remote codes in memory.
1. Open Hood (Ground the Blue wire if no hood pin is installed.)
2. Turn key to the ON position. (Doors will lock if Autolock is programmed)
3. Press Programming button 4 times, then after a few seconds the unit will flash the parking lights 4 times.
4. For CS2011RS systems: Press button #1 (Lock) of the transmitter; For 2-Way paging systems and "Sidekick" remotes:
Press Buttons #1 & 2 together. You should get 2 light flashes indication the unit is waiting for a 2
same combination of buttons on a second remote, the unit will flash 3 times indicating its waiting for the 3
PROGRAMMABLE OPTIONS
22
nd
code, then press the
rd
code and lights