Table of Contents
Advertisement
E. Baffle Board & Fiber Blanket
Baffle Board Service Part: SRV7095-117
Fiber Blanket Service Part: SRV7095-118
1. Remove all ash from the firebox, and extinguish all hot
embers before disposal into a metal container.
2. It is easier to remove both baffle boards and ceramic
blanket after the tube channel assembly has been
partially disassembled and the right side lowered. Follow
steps 1 through 4 on page 24 for removal of the tube
channel assembly. It is not necessary to completely
remove the tube channel assembly.
3. Once the baffle protection cover has been removed, pull
the baffle boards and ceramic blanket forward about
1 inch (25mm) and then overlap the baffles about 1-2
inches (25-51mm) (Figure 5.6).
4. Slide the tube channel assembly to the left as far as it will
go and lower the right side. Remove the baffle boards
and ceramic blanket together (Figure 5.7).
5. Re-install in reverse order. Be sure the baffle boards
and ceramic blanket are in their proper positions (See
Correct Baffle & Blanket Placement on page 19).
Ceramic Blanket
Figure 5.6
The ceramic blanket and both baffle boards
and tube channel assembly can all be
removed at the same time.
Figure 5.7
23
Baffle Boards Overlapping
Quadrafire • Expedition II AU Owner's Manual_Rev B • 2020 - ___ • 03/21
F. Wiring Diagram
Service Part: SRV7000-891
Five Setting Switch
Blower
Figure 5.8
G. Door Handle
Service Part: SRV7063-014
1. Install washer on door handle shaft.
2. Slide door handle through door.
3. Install additional washer(s) as shown in Figure 5.9.
4. Install key in groove.
5. Align groove in latch cam with key; slide latch cam
over shaft
6. Install locknut but do not over tighten, the handle needs
to move smoothly.
7. Install handle turning in a counter-clockwise motion to
desired location on door handle rod (Figure 5.9).
Door Cross
Latch Cam
Section
Locknut
Spacing
Washers
Figure 5.9
!
DO NOT over tighten lock nut. The door handle needs
to move smoothly.
Switch
Snap Disc
Power Cord
Door Handle Shaft
Square Key
Fiber Handle
CAUTION
7095-819
Advertisement
Table of Contents
