Headlamp High/Low-Beam Changer; Flash-To-Pass; Windshield Wipers - Chevrolet 2006 Epica Owner's Manual

Headlamp High/Low-Beam Changer

To change the headlamps from low beam to high beam,
push the turn signal/multifunction lever away from you.
To change the headlamps from high beam to low beam,
pull the turn signal lever toward you.

Flash-to-Pass

This feature lets you use your high-beam headlamps
to signal a driver in front of you that you want to pass.
To use it, pull the turn signal/multifunction lever
toward you until the high-beam headlamps come
on, then release the lever to turn them off.
3-8
When the high beams
are on, this light on the
instrument panel cluster
also will be on if the
ignition is turned to ON.

Windshield Wipers

Use this lever located on the right side of the steering
wheel to operate the windshield wipers. The ignition
must be turned to ON to operate the windshield wipers.
HI (High): Turn the lever to this position for wiping
at high speed.
LO (Low): Turn the lever to this position for steady
wiping at low speed.
INT (Intermittent): Turn the lever to this position to
choose a delayed wiping cycle.