Table of Contents
Advertisement
Using the Instrumented Calibration Mode
Using the Instrumented Calibration Mode for Simplex Printers
November 2011
10. To verify the calibration results:
• Select Current printer settings as a starting calibration
setting.
• Click Start Printer Calibration to make another test print.
11. Do Steps
3-10
until patch 25 is the most neutral gray and
match on both Side A and Side B calibration targets.
Use the instrumented calibration mode to calibrate simplex
(single-sided) or duplex printers. The instrumented calibration is
not supported for the following printers:
• KODAK Photo Printer 6800/6850
• KODAK 605 Photo Printer
NOTE: To use the instrumented calibration mode, you must have:
• an X-RITE i1PRO Device connected to your computer.
If there is not an X-RITE i1Pro Device connected, the
calibration application defaults to the visual calibration
method.
• the X-RITE i1PRO software installed on your computer.
Never print from another application during a
IMPORTANT:
calibration session. This could leave the printer
calibration in an unknown state.
1. Launch the KODAK Photo Printer Calibration Application.
2. At "KODAK Photo Printer Calibration Application", select:
• your printer model.
• the printer name and serial number.
• the starting calibration setting
– Current printer settings—use the current printer
settings as the starting point.
– Default printer settings—use the default printer settings
as the starting point.
• Instrumented for the Calibration Method.
Using the Calibration Application
3-5
Advertisement
Table of Contents
