Installing/Removing Hard Disk Drive With Easychange Rails - Fujitsu Siemens Computers SCENIC Edition X100 Operating Manual

System expansions

Installing/removing hard disk drive with EasyChange rails

This chapter only applies to the SCENIC Edition X100.
i
On the SCENIC Edition X100 the hard disk drive can be secured in the first installation bay
with EasyChange rails.
The second hard disk drive o the SCENIC Edition X100 can only be installed with screws
(see "Installing/removing hard disk drive with screws").
► Open the casing (see "Opening the casing").
Removing a hard disk drive
1
► Press the EasyChange rails mounted on the hard disk drive together somewhat (1) and pull the
hard disk drive out of the case in the direction of the arrow (2).
► Disconnect all cables connected to the drive (data cable, power supply cable).
i
It may be necessary to modify the entry for the drive in the BIOS Setup.
► Connect the cables to the hard disk drive.
► Close the casing (see "Closing the casing").
42
1
2
► Pull the EasyChange rails off the hard disk
drive.
A26361-K678-Z121-1-7619, edition 1