Replacing the floppy disk drive
►
Open the casing (see "Opening the casing").
Before you can replace the floppy disk drive, you must remove the power supply unit, see
!
the chapter "Removing the power supply".
►
Remove the data and power supply connectors from the floppy disk drive.
►
Remove the screws (1) on the left side of the floppy disk drive.
►
Slide the floppy disk drive out of the casing in the direction of the arrow (2).
►
Take the new floppy disk drive out of its packaging.
►
Slide the new floppy disk drive into the case opposite the direction of the arrow (2).
►
Fasten the floppy disk drive with the screws (1).
►
Fit the data and power supply connectors to the floppy disk drive. Make sure the polarity is
correct.
►
Close the casing (see "Closing the casing").
i
It may be necessary to modify the entry for the drive in the BIOS Setup.
A26361-K678-Z121-1-7619, edition 1
1
System expansions
2
41