System expansions
Installing/removing hard disk drive with EasyChange rails
This chapter only applies to the SCENIC Edition X100.
i
On the SCENIC Edition X100 the hard disk drive can be secured in the first installation
bay with EasyChange rails.
The second hard disk drive o the SCENIC Edition X100 can only be installed with screws
(see "Installing/removing hard disk drive with screws").
►
Open the casing (see "Opening the casing").
Removing a hard disk drive
1
►
Press the EasyChange rails mounted on the hard disk drive together somewhat (1) and pull
the hard disk drive out of the case in the direction of the arrow (2).
►
Disconnect all cables connected to the drive (data cable, power supply cable).
i
It may be necessary to modify the entry for the drive in the BIOS Setup.
►
Connect the cables to the hard disk drive.
►
Close the casing (see "Closing the casing").
42
1
2
►
Pull the EasyChange rails off the hard disk
drive.
A26361-K678-Z121-1-7619, edition 1