Jaycar Electronics DS-8704HI-S User Manual page 21

14 ESC
15 Reserved
16 F1
17 Lens control
18 F2
Loading the batteries into the IR controller
1. Remove the battery cover.
2. Insert the battery. Please take care that the poles (+ and -) are correctly
positioned.
3. Replace the battery cover.
Start to use IR controller
Press [DEV] key, input the DVR device ID (default is "88", can be changed in
"Display" menu) and then press [ENTER] key. If the "STATUS" lamp of DVR front
panel is turned into green, it means you can use IR controller to operate this DVR.
Stop using IR controller
When IR controller status is on, press [DEV] key again, the "STATUS" lamp will
be turned off. The IR controller can not control this DVR.
Switch the DVR off
When IR controller status is on, press [POWER] key for several seconds, the
DVR will be powered off.
When IR controller can not work normally
 Check batteries poles.
 Check the remaining charge in the batteries.
 Check IR controller sensor is mask.
Please change another IR controller to try again. If the problem is still existed,
please contact administrator.
Same as [ESC] key of front panel
Reserved for future usage
Same as [F1] key of front panel
IRIS, FOCUS ZOOM for lens control
Same as [F2] key of front panel
21