Table of Contents
Advertisement
Your Direct Vent Gas Fireplace comes equipped with an "Accent
Lamp." The light has been pre-wired and is controlled from the
Remote Control.
If in the event the lamp or lens needs to be replaced, follow the
instructions below:
1.
Unplug the Accent Lamp/transformer from the junction box
inside the fireplace.
2.
Remove the four screws that secure the lens frame. This frame
retains the glass lens. The bulb can now be accessed.
Note: Do not handle the lamp (bulb) with bare fingers, protect with
clean dry cloth.
The lamp will pull straight out of the socket. Replace with 10 Watt/12
Volt Halogen bulb.
When re-installing, ensure integrity of gasket seal.
THE FIREBOX MUST BE SEALED.
Over-tightening the screws could break the lens.
"Light Leakage" from the upper area may be observed. The holes
in the lamp housing are necessary for ventilation and must not be
covered.
Page 46
ACCENT LAMp
part Number
23116
R11117
R9658
R9341
R9342
Description
Cover
Lamp
Gasket
Glass
Bezel
Figure 49 - Accent Lamp parts
COVER
LAMP
GASKET
GLASS
BEZEL
29004-0-0711
Advertisement
Table of Contents
