Appliance Setup; Remove Fixed Glass Assembly; Remove The Shipping Materials; Clean The Appliance - Heat & Glo CERONA-36 Owner's Manual

Installation and operation
Hide thumbs Also See for CERONA-36:
Table of Contents

Advertisement

14
14

Appliance Setup

A. Remove Fixed Glass Assembly
See Section 14.G.
B. Remove the Shipping Materials
Remove shipping materials from inside or underneath the
fi rebox.
C. Clean the Appliance
Clean/vacuum any sawdust that may have accumulated
inside the fi rebox or underneath in the control cavity.
D. Accessories
Install approved accessories per instructions included
with accessories. Contact your dealer for a list of ap-
proved accessories.
WARNING! Risk of Fire and Electric Shock! Use ONLY
Hearth & Home Technologies-approved optional acces-
sories with this appliance. Using non-listed accessories
could result in a safety hazard and will void the warranty.
Heat & Glo • Cerona-36, Cerona-42 • 2106-900 Rev. K • 12/10
E. Ember Placement
WARNING! Risk of Explosion! Follow ember placement
instructions in manual. DO NOT place embers directly over
burner ports. Replace ember material annually. Improperly
placed embers interfere with proper burner operation.
Ember material is shipped with this gas appliance. To place
the ember material:
• There are two types of ember shipped with the appliance.
Embers for the burner surface and Mystic Embers for
the fl oor of the appliance.
• Embers CANNOT be placed directly over ports. Care
should be taken not to cover the lighting trail of ports
(from back to front).
• When placing Glowing Embers
should be taken so that the ports are not covered. Place
the dime-size ember pieces in front and behind of the
port trail, but not on or in between the ports (see Figure
14.1). Failure to follow procedure will likely cause lighting
and sooting problems.
• Place Mystic Embers on areas of base refractory away
from port holes. Use this material to give the appliance
a realistic ash bed.
• Save the remaining ember materials for use during
appliance servicing. The embers provided should be
enough for 3 to 5 applications.

EMBER PLACEMENT

Figure 14.1 Placement of Embers
®
onto the burner care
49

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Cerona-42

Table of Contents