Appliance Preparation; Removing Non-Combustible Facing Material Assembly; Securing And Leveling The Appliance - Heat & Glo CERONA-36 Owner's Manual

9 9

Appliance Preparation

A. Removing Non-combustible Facing Ma-
terial Assembly
CAUTION! Risk of Cuts, Abrasions or Flying Debris.
Wear protective gloves and safety glasses during instal-
lation. Sheet metal edges are sharp.
The non-combustible assembly is located on the back of
appliance (see Figure 9.1).
Remove screws
from upper bracket.
Figure 9.1 Non-Combustible Facing Material Assembly
CAUTION!
Handle with care. Non-combustible material may
be damaged if dropped.
• Hold non-combustible pieces in place.
• Remove and save two screws from upper brackets (see
Figure 9.1).
• Remove non-combustible pieces.
• Remove and save three screws from lower bracket (see
Figure 9.1).
• Discard brackets.
• Replace screws in holes where these pieces were
attached to appliance.
32
Lower
Bracket
Heat & Glo • Cerona-36, Cerona-42 • 2106-900 Rev. K • 12/10
B. Securing and Leveling the Appliance
WARNING! Risk of Fire! Prevent contact with:
• Sagging or loose insulation
• Insulation backing or plastic
• Framing and other combustible materials
Block openings into the chase to prevent entry of blown-
in insulation. Make sure insulation and other materials
are secured.
DO NOT notch the framing around the appliance
standoffs.
Failure to maintain air space clearance may cause
overheating and fi re.
The diagram shows how to properly position and secure
the appliance (see Figure 9.2). Nailing tabs are provided
to secure the appliance to the framing members.
• Bend out nailing tabs on each side.
• Place the appliance into position.
• Keep nailing tabs fl ush with the framing.
• Level the appliance from side to side and front to back.
• Shim the appliance as necessary. It is acceptable to use
wood shims underneath the appliance.
• Secure the appliance to the framing by using nails or
screws through the nailing tabs.
• Secure the appliance to the fl oor by inserting two screws
through the pilot holes at the bottom of the appliance.
The diagram shows (Figure 9.2) the location of the nailing tabs
provided to secure the appliance to the framing members.
NAILING
TABS
Figure 9.2 Proper Positioning, Leveling and
Securing of a Appliance