Epson TM-L90 series Service Manual page 72

Confidential
10. Remove the fixed blade holder spring by lifting up the claw.
Note:
The claw of the fixed blade holder spring is hooked to the platen holder. When removing it, do not pull
forcibly, as this may result in deformation. When installing it, make sure the claw has been hooked.
11. Remove the two E2 type E retaining rings and one paper feed roller shaft holder; then
remove the platen assembly.
Note:
When installing the paper feed roller shaft holder, see the drawing and engage it to the platen holder in
the correct direction.
Platen holder
E2
Install in the reverse sequence of removal.
Rev.C
TM-L90 Service Manual
Fixed blade holder spring
E2
Paper feed roller shaft holder
Platen assembly
Disassembly and Assembly 3-51