Epson TM-L90 series Service Manual page 34

Epson tm-l90 series line-thermal printer
Hide thumbs Also See for TM-L90 series:
Table of Contents

Advertisement

Confidential
Main Circuit Board Unit
1. Remove the cutter lead wire from connector
the lead wire.
When installing, route the cutter lead wire as shown below, and then fix with the insulating
tape.
2. Remove four S6 screws and remove the bottom plate. (See the illustration on the next page.)
3. Remove lead wire
4. Remove four S6 screws. (See the illustration on the next page.)
Note:
When tightening the four S6 screws, tighten in the order
tightened in any order, but should be tightened diagonally.
5. Remove the head FFC from connector
6. Remove the three lead wires from the main circuit board unit connector, in the order of
, and
.
7. Remove the switch circuit board FFC from connector
Note:
When replacing the switch circuit board FFC, note that the switch circuit board FFC is not bent when
provided as a service part. Bend it in the same way as the one that was installed into the printer. When
installing, hook the bent portion against the circuit board frame.
8. Remove the main circuit board unit.
Rev.C
Front view
Cutter lead wire
from the connector on the main circuit board unit.
on the main circuit board unit.
TM-L90 Service Manual
. Then, remove the insulating tape securing
Right side view
Cutter lead wire
Insulating tape
and
. The other two places can be
on the main circuit board unit.
Disassembly and Assembly 3-13
,

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents