Epson TM-L90 series Service Manual page 39

Confidential
5. Remove the two E-rings (E2).
6. Remove the two cover rotation shafts by pressing them inside.
7. Remove the roll paper cover unit. Then, pull the lead wire of the BM paper detector circuit
board assembly out through the clearance in the hinge cover.
Roll paper cover unit
To remove the roll paper cover unit, position the cover unit as shown below and pull out the
unit in the direction shown with the arrow in the illustration.
Note:
When you need to disassemble or assemble the roll paper cover unit further, see page 3-35 for instructions.
Install in the reverse sequence of removal.
3-18 Disassembly and Assembly
Cover rotation shafts
E2
Hinge cover
E2
Roll paper cover unit
Rev.C