Epson TM-L90 series Service Manual page 53

Epson tm-l90 series line-thermal printer
Hide thumbs Also See for TM-L90 series:
Table of Contents

Advertisement

Confidential
Frame R and Center Frame
1. Remove one S4 screw
2. Remove frame strengthening plate R.
3. Remove one S4 screw
4. Remove frame R.
5. Remove the center frame.
6. Remove one switch screw and remove the cover detector assembly from frame R.
Frame L assembly
Install using the following steps:
1. Affix the insulating tape on the cover detector assembly, as shown in the photo above. (This
process is necessary only if the original cover detector assembly has the insulation tape
affixed.)
2. Install the cover detector assembly onto frame R and secure with one switch screw. Then,
align the front and back so that the protrusion on the switch faces the position marked on
frame R.
3. Install the center frame. Then, route the lead wire of the paper feed motor forward. Align
two dowels on the center frame with two holes in the frame L assembly.
4. Install frame R.
5. Tighten one S4 screw at
6. Install frame strengthening plate R.
7. Tighten one S4 screw at
3-32 Disassembly and Assembly
.
.
Center frame
Frame strengthening plate R
.
.
Cover detector assembly
Frame R
S4
S4
Switch screw
Insulating tape
Rev.C

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents