Administration
Using the CLI to Upgrade Firmware
To download software from a TFTP/FTP Server, use the copy command from the Executive mode.
The copy command requires you to specify either the file type and then the server type, or the
server type and then the file type. You must then specify the file name, and IP address of the TFTP
server. When the download is complete, you can use the dir command to check that the new file is
present in the access point file system. To run the new software, use the reset board command to
reboot the access point.
Example
RoamAbout 4102#
RoamAbout 4102#copy tftp file
1. Application image
2. Config file
3. Boot block image
Select the type of download<1,2,3>:
[1]:1
TFTP Source file name:ets-img_v1017.bin
TFTP Server IP:10.120.112.2
Firmware version of system is V1.0.16 and Updating Run-Time code v01.00.17 NOW!
This firmware is compatible with hardware.
The software was properly copied over to the system and a reset is needed in order
for the software changes to take place.
RoamAbout 4102#
RoamAbout RBT-4102 Wireless Access Point Configuration Guide 4-43