Using the CLI to Display CDP Status
Use the cdp enable or cdp auto‐enable commands from the general configuration mode to enable
the AP to use CDP. Set CDP parameters using the cdp hold‐time, cdp tx‐frequency, and cdp
authentication commands. To view the current CDP settings, use the show cdp command from
the Executive mode.
Example
RoamAbout 4102#configure
Enter configuration commands, one per line. End with CTRL/Z
RoamAbout 4102(config)#cdp auto-enable
RoamAbout 4102(config)#cdp hold-time 300
RoamAbout 4102(config)#cdp authentication asdfg
RoamAbout 4102(config)#cdp tx-frequency 120
RoamAbout 4102(config)#exit
RoamAbout 4102#show cdp
CDP Global Information
========================================
Global Status
Authentication Code : asdfg
Transmit Frequency
Hold Time
========================================
RoamAbout 4102#
: Auto Enable
: 120 secs
: 300 secs
RoamAbout RBT-4102 Wireless Access Point Configuration Guide 4-99
Status Information