Ink Cartridge Safety Instructions - Epson Stylus Photo 890 Basic Manual

Place the printer on a flat, stable surface that extends beyond the printer base in all
directions. The printer will not operate properly if it is tilted or at an angle.
Turn off and unplug the printer before cleaning. Clean with a damp cloth only. Do not
spill liquid on the printer.
Always turn the printer off using the P power button. The P power light flashes briefly
and then goes off. Don't switch off the power strip or unplug the printer until the P
power light is off.
Do not block or cover the openings in the printer's case or insert objects through the
slots.
Except as specifically explained in this manual, do not attempt to service the printer
yourself.
Unplug the printer and refer servicing to qualified service personnel under the following
conditions:
If the power cord or plug is damaged; if liquid has entered the printer; if the printer has
been dropped or the case damaged; if the printer does not operate normally or exhibits a
distinct change in performance. Adjust only those controls that are covered by the
operating instructions.

Ink Cartridge Safety Instructions

Keep ink cartridges out of the reach of children and do not drink the ink.
Be careful when you handle used ink cartridges; there may be ink remaining around the
ink supply port. If ink gets on your skin, wash it off with soap and water. If it gets in your
eyes, flush them immediately with water.
Do not put your hand inside the printer or touch the cartridge during printing.
Do not move the print head by hand. You may damage the printer.
Install the ink cartridge immediately after you remove it from its foil package. Leaving the
cartridge unpacked for a long time before use can result in reduced print quality.
Do not use an ink cartridge beyond the date printed on the cartridge carton. For best
results, use up the ink cartridges within six months of first installing them.
Store ink cartridges in a cool, dark place.
After bringing an ink cartridge inside from a cold storage site, allow it to warm up at
room temperature for at least three hours before using it.
102