Epson Stylus Photo 890 Basic Manual page 96

Set the paper thickness lever to the
position. Set the lever to the
0
position when you print on thicker
paper or envelopes. You may also
need to turn off
printer software.
Your printout is blurry or smeared.
Make sure your paper isn't damp or
curled, or loaded face down (the
printable side should be face up). If
it's damp or curled, reload a new
stack of paper.
Use a support sheet with special
paper, or try loading your paper
one sheet at a time.
Make sure your paper meets the
specifications listed in the electronic
Reference Guide.
90
+
in the
High Speed
Use EPSON papers to ensure
proper saturation and absorption
of genuine EPSON inks.
Non-EPSON media may not be
compatible and may produce ink
bleeding or pooling.
Run the Print Head Alignment
utility. See page 80 for instructions.
Check the paper thickness lever
position. If it's in the
your printer is set for thicker paper
or envelopes and your image may
smear. For most papers, set the
paper thickness lever to the
position, as shown to the left.
Remove each sheet from the output
tray after printing, especially when
you're printing on transparencies.
position,
+
0