Printing On Paper Cut From A Roll - Epson Stylus Photo 890 Basic Manual

Printing on Paper Cut from a Roll

If you'll be printing on paper cut from a roll without using the roll paper holders,
follow the steps below.
1. Before loading the paper, cut it to the desired length of
your image plus two inches for the necessary margins.
Cut the edge cleanly, at a 90 degree angle
in each corner, to ensure proper loading.
2. Roll the edge of the paper
backward to uncurl it using a
folded sheet of paper to prevent
your hands from marring the
printable surface.
3. Remove the printer's paper support and
load the sheet, with the whiter side up, as
far as it will go. Slide the left edge guide
against the paper.
4. Gently hold the paper in place on the
top as you press and release the z roll
paper button to feed the paper into the
printer.
(If the paper feeds incorrectly, hold down
the z roll paper button for three seconds
to feed the paper backward. Repeat this
step until the paper rewinds completely.
Then reload the paper.)
5. Open your document in your application
software and access the printer settings
dialog box (see page 9 [Windows] or
page 16 [Macintosh] for instructions).
6. Select
Photo Paper
See page 37 for details about selecting the correct Media Type.
7. Select
Roll Paper
or
Premium Glossy Photo Paper
as the Paper Source setting.
as the Media Type setting.
69