HP ProCurve 3500yl Release Notes page 63

Enabling the Storage and Display of Security Credentials
To enable the security settings described in
included and viewed in the running configuration on the switch, enter the include-credentials
command.
Syntax: [no] include-credentials
Enables the inclusion and display of the currently configured manager and operator
usernames and passwords, RADIUS shared secret keys, SNMP and 802.1X authenticator
(port-access) security credentials, and SSH client public-keys in the running
configuration. (Earlier software releases store these security configuration settings only
in internal flash memory and do not allow you to include and view them in the
running-config file.)
To view the currently configured security settings in the running configuration, enter
one of the following commands:
• show running-config: Displays the configuration settings in the current running-config
file.
• write terminal: Displays the configuration settings in the current running-config file.
For more information, refer to the "Switch Memory and Configuration" chapter in the
Management and Configuration Guide.
To copy the contents of the running-config file from the switch to a USB flash memory
device, enter the copy running-config usb command. For more information, refer to the
"File Transfers" appendix in the Management and Configuration Guide.
The "no" form of the command disables only the display and copying of these security
parameters from the running configuration, while the security settings remain active
in the running configuration.
Default: The security credentials described in
page 44 are not stored in the running configuration.
"Security Settings that Can Be Saved" on page 44
"Security Settings that Can Be Saved" on
Enhancements
Release K.12.06 Enhancements
to be
52