Release K.12.20; Release K.12.21 - HP ProCurve 3500yl Release Notes

10-GbE Log (PR_1000424384) — The switch is not checking for the presence of the
■
J8694A ProCurve yl 10G X2-CX4 module early enough in the boot process, triggering a log
message when the check is executed.

Release K.12.20

The following problems were resolved in release K.12.20 (Never released.)

Release K.12.21

The following problems were resolved in release K.12.21 (never released).
ARP Protection (PR_1000438129) — ARP and ARP protection data may not display
■
correctly following a CLI or SNMP status query.
Enhancement (PR_1000440049) — Classifier-Based Rate Limiting capability was added.
■
Classifier-Based Rate Limiting (also known as Rate Limit Port ACLs or RL-PACLs) allows
you to create an ACL and apply it on a per-port basis to rate-limit network traffic.
■ CLI (PR_1000342461) — If a trunk is configured, output from the CLI command "show
lldp info remote <port number>" reports incorrect information for the remote management
address. This may result in a failure to discover or map devices connected to these trunks
by management applications that use LLDP discovery (e.g. ProCurve Manager).
■ Enhancement (PR_1000374051) — The 5400zl switches are not detecting packets from
an Avaya G700 PBX or Cajun switch due to irregular Ethernet packets sent by those devices.
This is a workaround that will alter the 5400zl software to allow 100Mb operation on the
upcoming "C" revision of the 1000 Base-T Mini-GBICs (J8177C) that fit in the J8705A module.
The port containing the 1000 Base-T Mini-GBIC can be configured with new speed options
of "auto-100," "100-full," and "100-half."
■ Crash (PR_1000434888) — A switch module may crash with a message similar to:
ACL Int status=0x10000000 28=0x80002f3a: Task=tDevPollTx Task
ID=0x4305c504 IP=0x400693e8
Enhancement (PR_1000443349) — This enhancement is to allow the concurrent use of
■
SFTP with TACACS+ authentication for SSH connections.
VRRP/Meshing (PR_1000435853) — A MESHed link in the path between a VRRP Owner
■
and VRRP Backup may lead to a situation where both VRRP routers remain in Master state
for a VRID after that VRID fails over to the Backup and then the Owner comes back online.
Software Fixes in Release K.11.12 - K.13.49
Release K.12.20
170