HP ProCurve 3500yl Release Notes page 146

Enhancements
Release K.13.19 Enhancements
Adding a Static Binding
To add the static configuration of an IP-to-MAC binding for a port to the lease database, enter the ip
source-binding command at the global configuration level. Use the no form of the command to remove
the IP-to-MAC binding from the database.
Syntax: [no] ip source-binding <vlan-id> <ip-address> <mac-address>
<port-number>
vlan-id
ip-address
mac-address Specifies a valid client MAC address to bind with
port-number
N o t e
Note that the ip source-binding command is the same command used by the Dynamic ARP Protection
feature to configure static bindings. The Dynamic ARP Protection and Dynamic IP Lockdown features
share a common list of source IP-to-MAC address bindings.
Verifying the Dynamic IP Lockdown Configuration
To display the ports on which dynamic IP lockdown is configured, enter the show ip source-lockdown
status command at the global configuration level.
Syntax: show ip source-lockdown status
135
Specifies a valid VLAN ID number to bind with
the specified MAC and IP addresses on the port
in the DHCP binding database.
Specifies a valid client IP address to bind with a
VLAN and MAC address on the port in the DHCP
binding database.
a VLAN and IP address on the port in the DHCP
binding database.
Specifies the port number on which the
IP-to-MAC address and VLAN binding is config-
ured in the DHCP binding database.