License Plate Lamp; Replacement Bulbs - Chevrolet 2010 Silverado Owner's Manual

4. Install a new bulb into the socket, turn it clockwise,
and press it in until it is tight.
5. Reinstall the lens and the four screws.

License Plate Lamp

To replace one of these bulbs:
1. Reach under the rear bumper for the bulb socket.
2. Turn the bulb socket counterclockwise and pull the
bulb socket out of the connector.
3. Pull the old bulb from the bulb socket, keeping the
bulb straight as you pull it out.
4. Install the new bulb.
5. Reverse Steps 1 through 3 to reinstall the bulb
socket.
6-62

Replacement Bulbs

Exterior Lamp
Back-up Lamp
Back-up Lamp*
Cargo Lamp and Center
High-Mounted Stoplamp (CHMSL)
Fender Marker Lamp
High-Beam Headlamp
Low-Beam Headlamp
License Plate Lamp
Sidemarker Lamp/Stoplamp/Taillamp/
Turn Signal Lamp
Stoplamp/Turn Signal Lamp/Taillamp*
* Chassis Cab Models
For replacement bulbs not listed here, contact your
dealer.
I n f o r ma t i o n P r o v i d e d b y :
Bulb Number
3047 or 921
1156
912
W5WLL
9005
H11
168
3047
1157