Finishing Material - Heat & Glo 6000GL-IPI-R Owner's Manual

C.

Finishing Material

It's very important to know what kind of a door and what
kind of finishing material is going to be used on the
fi replace. The table below shows the door models and the
fi nishing material thickness allowed. For an inside fi t there
is an available template to assist with sizing the fi nishing
material.
DOOR FIT
Folio Inside
Overlap
Arcadia
Inside
Overlap
Halston
Inside
Overlap
Chateau
Inside
Overlap
Valencia
Inside
Overlap
Galleria
Inside
Stop fi nishing material fl ush with opening.
Figure 11.4 Folio Door
Finishing materials 1 inch maximum thick.
Stop fi nishing material fl ush with opening.
Figure 11.5 Overlap Fit Door
FINISH
MATERIAL
SEE FIGURE
MAXIMUM
THICKNESS
Any 11.4
1 inch 11.5
Any 11.6
1 inch 11.5
1 inch - 3 inch 11.7
1 inch 11.5
Any 11.6
1 inch 11.5
Any 11.6
1 inch 11.5
1 inch - 3 inch 11.7
ELBOW
HEAT
SHIELD
Heat & Glo • 6000GL-IPI-R, 6000GL-IPI-S • 2102-900 Rev. B • 5/06
ELBOW
FINISHING
SHIELD
MATERIAL
DOOR
37-1/4 in.
(Includes 1/8 in. opening each side of door)
37 in.
(Outside door width)
37-1/4 in.
(Includes 1/8 in. opening each side of door)
Finishing materials over 1 inch thick.
Figure 11.6 Inside fi t door
1-3 in. THICK
FINISHING
MATERIAL*
*If finishing material is thicker than
3 in., doors will only open
as far as pictured.
DOOR
37 in.
37-1/4 in.
Finishing material between 1 and 3 inches thick.
Figure 11.7 Operable hinge door
HEAT
FINISHING
MATERIAL
37 in.
(Outside door width)
33-3/4 in.
34 in.
1-3 in. THICK
FINISHING
MATERIAL
34 in.
33-3/4 in.
39