Power Supply Requirements - Sundance Spas Solo Installation & Owner's Manual

5.0 Power Supply Requirements

US/Canada 120/240 VAC Convertible Models (60 Hz)
Voltage:
Frequency:
Current Draw:
# of Wires
Circuit Breaker
For 240 VAC Heater Operation: Move the red wire on the main terminal
strip (TB1) from position #1 to position #3. Make certain wires are
connected exactly as shown in figure-H (page 8) before applying power.
Failure to do so will result in damage to the circuit board and/or related
components and void the manufacturer's warranty.
* In the 15 A / 25 A configuration, the heater will not operate at the
same time as the main pump. The factory setting is 120 VAC/15 A.
** If the spa is to be operated on 40 A service, remove the jumper JP1
#1&2 on the circuit board to allow the heater to operate at the same
time as the main pump (see page 30).
US/Canada 240 VAC Caprio ST Models (60 Hz)
Voltage:
Frequency:
Current Draw:
Breaker:
All Export 230-240 VAC Models (50 / 60 Hz)
Voltage:
Frequency:
Current Draw:
Breaker:
Important Information: The Portofino series spa can be adapted to use
higher amperage circuits when available. Please contact your dealer for
details. The electrical supply for this product must comply with local
electrical regulations. The factory setting is 230 VAC/20 A.
120 VAC/
15 A*
120 VAC
60 Hz
12 A
3 (15 A cord/GFCI)
15 A, 1-Pole
240 VAC
60 Hz
18 A / 29 A
25 A* / 40 A
230-240 VAC
50 / 60 Hz
13 A / 19 A
20 A / 30 A
240 VAC/
25 A*
240 VAC
60 Hz
18 A
4
25 A, 2-Pole
*Note: in the 25 A configuration,
the heater will not operate at the
same time as the main pump.
The factory setting is 240 VAC/
40 A.
240 VAC/
40 A**
240 VAC
60 Hz
30 A
4
40 A, 2-Pole
7