Operating Instructions; Setting Water Temperature; Pump Button; Light Button - Sundance Spas Solo Installation & Owner's Manual

9.0 Operating Instructions

The spa control system has automatic functions that operate upon
start-up and normal operation to protect the system. Upon power
up, the readout displays the following information:
1. Control displays current software release
(e.g. 3.50), then;
2. Control panel displays "888" and all indicator LEDs
are lit, permitting visual inspection of all display
segments and indicator lights for proper operation.
3. After the initial start-up sequence ends actual water
temperature is displayed. If water temperature at
this time is less then the factory default temperature setting of
100 °F (38 °C), the circulation pump and heater will turn on and
run until the water temperature rises to the factory default tem-
perature setting. Then the heater turns off and the circulation
pump remains on for 24-hour operation. Note: it is common for
the heater to turn on after the spa is first filled because tap water
is often very cold.

9.1 Setting Water Temperature

The spa's thermostat provides optimum control of water
temperature. The temperature setpoint (set temperature)
can be adjusted from 65 °F to 104 °F (18 °C to 40 °C).
To raise the set temperature, press the WARMER
arrow button. To lower the set temperature, press the
arrow button. Note: The first press of either WARMER
COOLER
or COOLER

9.2 Pump Button

The JETS button activates the functions of the pump.
The first press activates low speed, the second press
activates high speed, and the third press shuts the pump
off. The pump has a twenty-minute default when
manually activated.

9.3 Light Button

The LIGHT button activates the spa light when pressed.
The light has a one-hour default.
12
button displays the set temperature.
Startup
Sequence
1.
2.
3.