Care And Maintenance; Cleaning The Filter - Sundance Spas Solo Installation & Owner's Manual

Lock Modes
L1 Lock Out (disables all hot tub functions to permit
filter cleaning)
L2 Lock Mode (disables the jets and light buttons to
prevent unauthorized use of the hot tub) - filter cycles and
heater will continue to operate as programmed in this mode.
The temperature display flashes when this function is enabled.
Example: the "F3" filter cycle was enabled prior to choosing lock
mode. The hot tub continues to perform filter cycle "F3" until
lock mode is canceled, allowing another filter cycle to be
selected.
To set a time for the first filter cycle, simply turn power on to the spa
two minutes prior to the desired filter time. EXAMPLE: If you desire
your first filter cycle to begin at 10:00 AM turn off power to the spa
and turn it back on again at 9:58 AM. Note: start time is approximate
and may vary slightly from day to day.

10.0 Care And Maintenance

Proper and regular maintenance of your spa will help it retain its
beauty and performance. Your authorized Portofino dealer can
supply you with all the information, supplies and accessory products
you will need to accomplish this.

10.1 Cleaning The Filter

Solo Models - These models are equipped with a double-ended
polyester mesh (pleated) filter cartridge under the filter lid (section
14.1, page 28). Debris are filtered 24-hours by the circulation pump
drawing water through the smaller side of the cartridge. Larger
debris are filtered by the main 2-speed pump drawing water through
the larger side of the cartridge during normal operation and during
each filter cycle. Combined, both halves work together to give you
clean water by trapping suspended particles on their outer surface.
Note: To ensure optimum performance, clean and reuse the filter
cartridge once a month.
Tango, Caprio, and Caprio ST Models - These models are
equipped with an exclusive MicroClean
located under the filter lid (section 14.2-14.3, page 29) . Fine debris
16
TM 2-stage filter cartridge