Surround Panels - Lopi Freedom Bay Fireplace Insert Owner's Manual

Surround Panels

NOTE: Install the door shell (and side frames) prior to installing the surround panels.
SURROUND PANEL SIZE
8" (204mm)
10" (254mm)
12" (305mm)
Installation Instructions
1. With the insert 12"
(305mm) from the
fireplace, install the side
surround panels (see the
directions to the right).
2. Adjust the position of the
side panels so they are: 1)
flush with the bottom of the
insert; 2) both the same
distance back from the
front of the insert; 3)
perpendicular to the floor
(use the top panel, if
necessary, to judge
alignment). Tighten the
screws that hold the side
panels in place.
3. Place the insert into the
fireplace and connect the
flue (if using a positive or
direct connection). Install
the top panel and trim
following the directions
below.
2. Push the insert into the fireplace, allowing the insulation to form a seal between the panels and the
fireplace. Use a screwdriver to tuck any exposed insulation behind the panels.
© Travis Industries
Optional Equipment
HEIGHT
29-1/2" (750mm)
31-1/2" (801mm)
33-1/2" (851mm)
a
Place two U-Nuts (included
with the insert) over the inside
flange on one of the side
surround panels (flat side in).
Back Side
of Side
Surround
Panel
The flat side
faces inwards.
Spring
Clips
Install the top panel so the tabs insert
into the joggle clips on the top panel
100-01163
WIDTH
45-3/8 " (1153mm)
49-3/8 " (1255mm)
53-3/8 " (1356mm)
Stove Top
b
Rotate the panel back
and place it so the inside
flange fits inside the side
convection jacket. Note
how the stove top fits
into the notch.
Notch
Top
Panel
PART #
99300293
99300294
99300295
Top of Insert
Side
Convection
Jacket
c
Attach the side panels with the two screws
included with the insert. The screws pass
through the side convection jacket and
attach to the U-Nuts. Do not tighten the
screws fully until the panels are aligned.
Micro (1/16")
Standard
Screwdriver
Top Trim
"L" Bracket
Right Side
Trim
Optional Trim Installation:
Insert one leg of each "L" bracket into the top
and side trim piece. Align the trim to form a
precise corner, then tighten the two set
screws with a small standard screwdriver.
Slide the trim over the panels. Place the
spring clips behind the panels at the locations
shown. This keeps the trim tight against the
panel.
Optional Knock-Out
An optional knock-out is provided on both
sides if the power cord is routed behind the
surround panel.
4041129
33