Empire Comfort Systems VFLL38FP30L-1 Installation Instructions And Owner's Manual page 17

2. To install the Decorative Glass, cut off a corner of the plastic
bag and proceed to apply the glass to the rear shelf on the
Loft burner (area behind the burner). Apply only enough glass
to the Top Cover to cover the black metal surfaces. Do not
allow the glass to fall around the burner tube. See Figures
20 to 22. Apply the remaining decorative glass to the front
sloped surface of the Top Cover. Start by placing the glass
along the front edge of the top cover, then gradually place the
glass around the top until completely covered. Do not allow
the glass to fall around the burner tube. See Figure 21.
Glass or rocks must not be placed around the ends of the
Loft burner assembly that would restrict air flow.
29516-10-0713
CAUTION
Figure 20
Figure 21
Figure 22
3. Replace the glass front into the fireplace by placing the right
side into the slots in the firebox. Carefully angle in the left side
of the glass and then slide the glass to the left. Settle the glass
into the slots by gently lowering it.
TOP VIEW
Figure 23
Figure 24
Figure 25
Figure 26
Page 17