Door And Glass Inspection; Adjusting The Door Cam - Lopi Liberty Owner's Manual

M
AINTAINING
P 24
AGE
D A G
OOR ND LASS
The door must seal air-tight for the appliance to work correctly. Check the two items below and follow
the appropriate remedy to fix any problems.
¥ Check the door cam operation. When closed, the door cam should pull the door against the face
of the appliance, but not be so tight as to not allow the handle to point downwards. If the
operation is not correct, see the section "Adjusting the Door Cam" below.
¥ Remove the door by opening it and lifting it off the hinges. Place the door face down and check
the door gasket (see the illustration below). If the door gasket requires replacement, see the
section "Replacing the Door Gasket" on the following page. Check the glass and glass gasket. If
the glass or gasket require replacement, see the section "Replacing the Glass or Glass Gasket" on
the following page.
The door gasket should
be unbroken, have
enough bulge to contact
the face of the unit, and
be firmly attached to the
door frame.
The glass gasket
should form an
airtight seal
between the glass
and the door frame.

Adjusting the Door Cam

If the door cam does not pull the door against the face of the appliance, the door cam will need to be
tightened (see the illustration below for details). If the door handle does not turn down all the way, it is
too tight and will need to be loosened (see the illustration below for details). Before adjusting, remove
the door by opening the door and lifting it off the hinges.
Side View of Door Handle
Door Cam
Y A
OUR PPLIANCE
I
NSPECTION
Washers
Door Frame
(C
ONTINUED
Exploded View
Door
Handle
Use a 9/16"
socket wrench to
remove this nut.
)
Check the
glass for any
cracking.
Door Cam
Door Cam
Adjustment:
To tighten, remove
a washer from the
inside of the door
frame. To loosen,
place an additional
washers on the
inside of the door
frame or loosen
the nut 1/2 turn.