Interfaces - NetComm NTC-6000 Series User Manual

Interfaces

FIELD
Main Antenna Socket
Receive Diversity Antenna Socket
Serial RS-232 Port
Indicator LEDs
Power Terminal Block
Reset Button
NetComm Wireless 3G M2M Router
8
Figure 2 - Interfaces – Left Side View
Figure 3 - Interfaces – Right Side View
DESCRIPTION
SMA female connector for external antenna.
SMA female connector for external antenna.
For connecting to a terminal using a DB9-F cable.
Indicates the connection strength, service type, data traffic, data carrier connection and
network connection strength.
Terminate power wires here and connect to DC power source (8-28V). Correct polarity is
shown on page 10.
The reset button has multiple functions.

Reboot the device: Press and hold the reset button down for no longer than 5
seconds. All LEDs remain off, when the button is released the green LEDs flash
once and the router reboots.

Reboot to recovery mode: Press and hold the reset button down for between 5
and 15 seconds. When the LEDs are flashing, release the button and the amber
LED flashes. The router reboots into recovery mode.

Factory reset the device: Press and hold the reset button down for more than 15
seconds. When all the LEDs are off, release the button. The Red LED flashes to
confirm the factory reset process. If you change your mind after holding the reset
button down for more than 15 seconds, you can cancel the factory reset by
removing the power source before releasing the button or by releasing the
button and quickly pressing it once more.
www.netcommwireless.com