Configuring Your Router; Setting Up The Cellular Router - NetComm NTC-6000 Series User Manual

Configuring your Router

You will need the following hardware components to set up the router:
Power supply (8-28VDC)
Ethernet cable
Laptop or PC
Active SIM card
Inserting the SIM Card
Use a paperclip to press the SIM Eject button to eject the SIM card tray. Place the SIM card in the SIM card tray. Make sure the
SIM card is inserted correctly by inserting the SIM with the gold side facing down into the SIM card bay and in the direction as
shown below:

Setting Up the Cellular Router

Attach the supplied antennas to the router by screwing them onto the antenna connectors. Connect the power adapter to the
mains and plug the output into the power jack of the router. When power is correctly supplied to the router, the red power LED on
the panel illuminates.
Polarity of DC Power Plug Screw Terminal
NetComm Wireless 3G M2M Router
10
Press the SIM Eject button
Insert your Mobile Broadband SIM Card
Figure 4 - Inserting the SIM Card
Figure 5 – Locking Two-way Power Terminal Block
PIN SIGNAL DESCRIPTION
+ V+ Voltage +
- V- Ground
Table 4 - Locking power block pin outs
www.netcommwireless.com