Restoring Factory Default Settings - NetComm NTC-6000 Series User Manual

Restoring factory default settings

Restoring factory defaults will reset the NTC-6000 Series router to its factory default configuration. You may encounter a situation
where you need to restore the factory defaults on your NTC-6000 Series router such as:
You have lost your username and password and are unable to login to the web configuration page;
You are asked to perform a factory reset by support staff.
There are two methods you can use to restore factory default settings on your NTC-6000 Series router:
Using the web-based user interface
Using the reset button on the interface panel of the router
Using the web-based user interface
To restore your router to its factory default settings, please follow these steps:
1. Open a browser window and navigate to the IP address of the router (default address is http://192.168.20.1). Login to the
router using root as the User Name and admin as the password.
2. Click the System item from the top menu bar, then System configuration on the left menu and then click Settings backup
and restore.
3. Under the Restore factory defaults section, click the Restore defaults button. The router asks you to confirm that you wish
to restore factory defaults. Click OK to continue. The router sets all settings to default. Click OK again to reboot the router.
4. When the Power light returns to a steady red, the reset is complete. The default settings are now restored.
Using the reset button on the interface panel of the router
Use a pen to depress the Reset button on the device for more than 15 seconds. When the LEDs are no longer flashing, release the
reset button to restore the router to factory default settings. The red LED flashes indicating that you have initiated a factory reset
procedure. If you change your mind after holding the button down for more than 15 seconds, you can cancel the factory reset
process by disconnecting the power source while still holding the reset button down. Alternatively, you can release the reset button
and quickly press it once more.
When you have reset your NTC-6000 Series router to its default settings you will be able to access the device's configuration web
interface using http://192.168.20.1
www.netcommwireless.com
with username admin or root and password admin.
NetComm Wireless 3G M2M Router
RouterRouter/
107