Operator Settings - NetComm NTC-6000 Series User Manual

Operator settings

The Operator settings page enables you to select which frequency band you will use for your connection and enables you to scan
for available network operators in your area.
Note: In order to change the operator's band settings, the data connection must be disabled. When you access this page,
you are prompted to disable the data connection if it is already active.
You may want to do this if you're using the router in a country with multiple frequency networks that may not all support High Speed
Packet Access (HSPA). You can select the router to only connect on the network frequencies that suit your requirements.
Use the Change band drop down list to select the band you wish to use.
The following band settings options are available:
UMTS 850MHz, 2G
UMTS 850MHz Only
2G
WCDMA All
Autoband
GSM 900/1800
WCDMA 900/2100
2G
WCDMA ALL
Autoband
It is not necessary to change the default setting of All bands in most cases. In fact, locking to a particular band can cause
connection difficulties if the device is moved to a location where the forced band selection is no longer available.
When All bands is selected, the router attempts to find the most suitable band based on the available networks for the inserted SIM
card.
The GSM All and the WCDMA all options allow you to force the device to lock to either 2G networks only, or 3G networks only.
Click the Save button to save and apply your selection.
www.netcommwireless.com
Figure 12 - Band settings
NTC-6908
NTC-6908-02
NTC-6520
All bands
WCDMA 2100
WCDMA 850/1900
GSM 900/1800
GSM 850/1900
GSM ALL
WCDMA 2100 GSM 850/1900
WCDMA 850/1900 GSM 850/1900
WCDMA All
WCDMA 850/2100
WCDMA 850/2100 GSM 900/1800
WCDMA 850 GSM 900/1800
WCDMA 850
WCDMA 900
WCDMA 900/2100
Table 9 - Band settings
NetComm Wireless 3G M2M Router
RouterRouter/
19