Fastening Stand To Supporting Surface; Operating Controls And Adjustments; Starting And Stopping Saw; Locking Switch In The "Off" Position - Delta 36-444 Instruction Manual

FASTENING STAND TO SUPPORTING SURFACE

WARNING: IF DURING OPERATION THERE IS ANY TENDENCY FOR THE SAW TO TIP OVER, SLIDE OR
WALK ON THE SUPPORTING SURFACE, THE SAW STAND SHOULD BE SECURED TO THE FLOOR
SURFACE. THE RUBBER FEET OF THE STAND FEATURE HOLES WHICH ALLOW EASY MOUNTING
WITHOUT REMOVING THE SAW FROM THE STAND.

OPERATING CONTROLS AND ADJUSTMENTS

STARTING AND STOPPING SAW

1. The on/off switch is located underneath the switch
shield (A) Fig. 39. To turn the saw "ON," move switch
trigger (B) to the up position.
2. To turn the saw "OFF," push down on switch shield
(A) Fig. 40.
A
B
Fig. 39
Fig. 40
LOCKING SWITCH IN
THE "OFF" POSITION
IMPORTANT: When the machine is not in use, the
switch should be locked
prevent unauthorized use,
with a 3/16" diameter shackle.
A
16
in the "OFF" position to
using a padlock (C) Fig. 41
Fig. 41
C