Operation; Operating Burners - Amana AKS3020 Owner's Manual

Use a dedicated 120 volt, 60 hertz, 3-prong receptacle
protected by a 15 amp circuit breaker or time delay fuse.
A qualified electrician should confirm the outlet is properly
grounded. Cooktop includes 4-foot power cord attached to
bottom of cooktop.
Grounded Plug and Receptacle
If a 2-prong outlet is encountered, cooktop owner must
replace outlet before using cooktop. Do not cut off cord or
remove grounding prong.
When installed in mobile housing, installation is to be in
accordance with CSA standard Z241.1 gas equipped
mobile housing. All electrical connections are to be made
in accordance with CSA standards Z240.6.1 electrical
requirements for mobile homes.
The installation of appliances designed for manufactured
(mobile) home installation must conform with
Manufactured Home Construction and Safety Standard,
Title 24 CFR, Part 3280, or when such standard is not
applicable, the Standard for Manufactured Home
Installation, ANSI225.1/NFPA 501A-Latest Edition, or
with local codes or the standard CAN/CSA-z240MH,
"Mobile Homes", and with local codes where applicable.
The installation of appliances is to be in accordance with
CAN1-B149.1 or B149.2 installation code for gas burning
appliances and equipment and/or local codes. Part 1
and/or local codes.
All electrical connections are to be made in accordance
with CSA C22.1 Canadian Electrical Code.

Operation

Operating Burners

1. Push and turn burner control knob to "LITE" position.
• Burner sparks until turned from "LITE".
2. Turn burner control knob to desired setting.
3. Turn burner control knob to "OFF" position when
finished.
• Refer to cooktop rating plate for individual burner
ratings.
MED
Surface Burner Controls
Delayed Ignition
Burner should ignite within 4 seconds. If burner does not
ignite within 4 seconds turn control knob to OFF position
and follow directions in "Placing Grates and Burner Caps"
section. Try burner again. If burner still does not ignite in
4 seconds, contact an authorized servicer.
Burner Flame Size
• While turning the burner control knob, watch the burner
flame.
• Flame size should match the size of the pan. Do not
allow the flame to extend up the sides of the pan.
Flames that extend up the sides of the pan can ignite
clothing, make handle hot, or burn.
Burner Flame Size
10