Table of Contents
Advertisement
9. MAINTENANCE
The safety and integrity designed into the machine can only be maintained when the equipment is regularly examined for damage
and repaired. It is the sole responsibility of the user/owner to ensure that regular maintenance is performed. Worn or damaged
components shall be replaced immediately and stop using the equipment until the repair is made. Only manufacturer supplied
components shall be used to maintain/repair the equipment.
1.
Wipe the home gym regularly to prevent accumulation of dust.
2.
Use a damp cloth on plastic parts only, use dry cloth on metal frames.
3.
Upholstery: Wipe down all upholstery with a damp cloth as needed.
4.
Avoid acid chlorine based cleaners and also cleaners containing abrasives as these could scratch or damage the equipment
5.
Pay close attention to wear and tear of ropes, belts, or chains and their connections.
6.
Keep this product indoors, away from moisture and dust. Do not put it in a garage or covered patio, or near water.
7.
Check regularly to ensure all parts are tight and in working condition. If a part is damaged do not use until the part is
replaced or repaired.
8.
Place the home gym on a level surface with a mat beneath it to protect your floor or carpet
9.
Do not install any fitness product near a pool, hot tub or other damp locations. Corrosion caused by installation in these
locations can lead to premature failure of components.
10.
Inspect all nuts and bolts for looseness. Tighten as required.
11.
Verify that all adjustments can be made into each position.
12.
Verify that any adjustment pins insert freely into each position and is fully engaged.
13.
Make sure that all locking mechanisms work and lock securely before using the unit.
14.
Inspect all labeling for readability. This includes warning and caution decals. Replace them as needed.
15.
Always wear athletic shoes for foot protection.
16.
Keep hands and feet away from moving parts.
17.
Never exercise alone, always have someone present to ensure your safety when using this product
10. OPERATIONAL INSTRUCTIONS
To adjust the tension of the cables, first make sure the weight stack is not in an elevated position; pull the cable to the desired
tension and then adjust the chain link.
Make sure the weight stack lock out mechanism is in place after each use of the machine to prevent the inadvertent use by
children.
Make sure to remove the lock out mechanism before commencing your exercise routine
Make sure to engage and disengage the locking pin on top of the main frame when switching from using the bench press to
using the butterfly arms
11. MANUFACTURER'S LIMITED WARRANTY
This warranty applies to products purchased in the CONTIGUOUS UNITED STATES and covers your product against defects in
Materials, and workmanship when used for the intended purpose under normal use and conditions, provided that the product
receives normal maintenance and care. The warranty is for the original owner only. This warranty covers defects in material or
craftsmanship for 30 days from date of purchase. Sales receipt required. This warranty does not cover pads, rollers, rubber
pieces, bolts or nuts unless missing or damaged in original box. It does not cover any damages due to misuse or exceeding the
recommended weight capacity. This warranty is void in cases where the product is used in a commercial, rental, or other non-
home use setting. Manufacturer will provide a replacement part at no charge for any part found defective in materials or
workmanship during the specified warranty period. Under no circumstances will the manufacturer be responsible for damages or
failures that occur as a result of improper assembly or failure to operate the product correctly. This warranty does not cover
misuse, neglect, accident, alterations, or repairs made by an unauthorized service representative. Warranty voided outside of
the United States. Proof of purchase is required for all warranty claims. Use of this product creates an agreement between the
manufacturer and the user of this product to resolve all disputes, claims, or controversies whatsoever arising from or relating to
this product, including the validity of this arbitration clause, by binding arbitration pursuant to Section 2 of the Federal Arbitration
Act. Maximum judgment for all causes of action shall be limited to $10,000. The parties agree and understand that by using this
product they choose arbitration instead of litigation to resolve disputes. If buyer(s) choose not to enter into this agreement, they
may return unused product to the place or purchase. IMPORTANT: To help us assist you, be prepared to provide the model no.,
name of the product and key number for replacement parts found on this manual.
CAP Barbell, Inc.
10820 Westpark Dr.
Houston, TX 77042
Customer Service:
M-F 9am-5pm CST
1-877-227-0955
STOP!
Need a part or need assembly
assistance?
Do not return it to store!
Call our service line:
1-877-227-0955
17
Printed in China
Hide quick links:
Advertisement
Table of Contents
