ASSEMBLY INSTRUCTION: STEP 1 30 27 A.) Push two Inner Caps (#33) into the Front Stabilizer (#4). Push two Rubber End Caps (#32) into the Rear Stabilizer (#5). B.) Attach a U-shaped Sleeve (#34) onto the bracket on the Front Stabilizer (#4). Make sure the opening on the Sleeve is facing towards the front.
Page 6
STEP 2 A.) Push two Square Inner Caps (#35) into the Backrest Support (#6). Push one M6 x 15mm Screw (#24) and Rubber Bumper (#37) into the Incline Support (#7). Attach the Incline Support (#7) in between the two Backrest Supports (#6). B.) Attach the Pivot of the Backrest Supports (#6) to the Pivot on the Center Support Frame (#1).
Page 7
STEP 3 A.) Place the Seat (#13) onto the Center Support Frame (#1). Secure it to the two L-shaped Brackets (#12) with two M8 x 15mm Bolts (#23) and M8 Washers (#30). Secure the Seat to the Center Support Frame with one M8 x 45mm Bolt (#21) and M8 Washer (#30).
All of these are for the original owner only. This warranty is not valid in cases where this product is used commercially. CAP Strength will provide a replacement part at no charge for any part found defective in materials or workmanship during the specified warranty period.