Section 8: Removing & Installing The Door - Montigo R520 Installation & Maintenance Manual

R520 & R620 Power Vent Indoor Gas Fireplace
Section 8: Removing & Installing the Door
Removing the door trim:
Follow the steps below to remove, or install the R520* / R620*
fireplace door trim.
Step 1:
Grasp the trim on either side of the
door with the tips of your fingers.
(Both sides Typ.) Pull firmly to re-
lease the trim from the internal
door magnets.
Step 3:
Remove the trim from the bottom
of the door as shown.
Page 32
Installation
Step 2:
Then, pull the trim from the top of
the door, as shown.
Step 4:
Remove the other side, as
shown in Steps 1 - 3.
Removing the door:
Follow the steps to remove, or install the R520*/R620* fireplace door.
Step 1:
Remove glass suction cups from box and place on Glass door. (The
tool may not be exactly as shown).
Step 2:
Place the suction cups on the glass door, spaced evenly. (Ensure
they are firmly attached, and secured.)
Step 3: Lifting the glass panel.
Hold the Tools firmly and lift the glass panel up and out of the lower
track (Into the upper track). Tilt the lower edge of the door panel
outwards.
Step 4:
Ensure the top edge of the glass is fully removed from the upper outer
track, and Tilt / Lift away Cautiously from the fireplace. Store in a safe
location until time to replace.
Reinstalling the door:
Follow the four previous steps to re-install the R-Series fireplace door.
XG0771 - 040513.3