Fujitsu DL7400 User Manual page 133

User's Manual
Table 5.6 CONFIG Items and Options (Cont.)
NOTE: Underlined options are the factory defaults.
Options
CONFIG
Items
GATHER
ENABLE
DISABLE
CUT-CTL
PRCISIN
SPEED
USING SETUP MODE
Description
Setting of ribbon protective control at
a line feed on continuous forms
The protective control is executed.
The protective control is not
executed.
Setting of retracting control at
canceling TEAR OFF of continuous
forms.
The precision-prioritized retracting
control is executed.
It retracts a certain amount of paper
(the top part of the paper which hangs
out from the TOFS), and then moves
back to the position before TEAR
OFF. If TOFS detects paper end
when a certain amount of paper is
retracted, it executes the continuous
forms save operation and then
executes the paper loading operation.
The speed-prioritized retracting
control is executed.
It retracts the paper by the amount the
paper was advanced.
5-43