Paper Motor Removal - HP 650C User Manual

PAPER MOTOR REMOVAL

The drive roller gear and paper motor must be replaced at the same time.
To remove the paper motor and drive roller gear, perform the following procedure:
1. Remove the right endcover.
2. Remove the electronics enclosure cover.
3. Remove the carriage motor.
4. Remove the front panel assembly.
5. Disconnect the paper motor cable connector (labeled P) from the interconnect PCA.
6. Disconnect the encoder cable connector from the paper motor. See Figure 6-19.
Note the orientation of the mark (9 0'clock position) on one side of the drive
roller gear for installation purposes.
7. Using a TORX T-10 screwdriver, remove the two screws that secure the drive roller
gear to the drive roller shaft and remove the gear.
8. Using a TORX T-20 screwdriver, remove the two screws that secure the ink drop
well and remove the well.
9. Using a TORX T-15 screwdriver, remove the two screws that secure the paper motor
to its bracket.
10. Pull the paper motor toward the rear of the plotter until the motor can be removed
from the plotter.
If installing a new motor, apply grease (supplied with the motor) to the motor worm gear.
Ensure that the mark on the drive roller gear faces to the front of the plotter
(9 0'clock position) when the motor worm gear is fully engaged with the
drive roller gear.
6-26 Removal and Replacement
Note
Note
Note