Usable Media Sizes; Loading Roll Media - HP 650C User Manual

USABLE MEDIA SIZES

Media of different types and sizes can be used on the plotters. Refer to Table 3-1 for the media
sizes usable on each plotter.
C2858A
ISO A4 - A1
ANSI A - D
ARCH A - D
JIS B4 - B2
Oversize A2
24 in. Wide Roll

LOADING ROLL MEDIA

If the spindle is already loaded into the plotter, remove the spindle by opening the roll cover
and pulling on both ends of the spindle to remove it from the plotter. To load roll media into
the plotter, put a roll of media on the plotter spindle and insert the spindle in the plotter by
performing the following steps:
W A R N I N G
1. Standing the spindle on the end opposite the large, scalloped media stop,
scalloped media stop to release the spindle from the used roll. Set the spindle aside.
Turn the used roll over and slip the endcap out with your finger. See Figure 3-2.
2. Slide the roll onto the spindle with the leading edge winding clockwise. Push the
endcap into the media core, making sure the tabs are flush against the edge of the
roll. See Figure 3-3.
3-6 Installation and Configuration
Table 3-1. Media Sizes
Be sure that the plotter wheels are locked to prevent
the plotter from moving while loading roll media. To
lock the wheels, press the locking levers on the wheels
to the down position.
C2859A
ISO A4 - A0
ANSI A - E
ARCH A - E
JIS B4 - B1
Oversize A1
24 in. Wide Roll
36 in. Wide Roll
pull the