Drive Roller Cleaning - HP 650C User Manual

DRIVE ROLLER CLEANING

W A R N I N G
If ink is spilled on the drive roller, remove the ink. Due to the ink's reflectance, ink on the
roller can disrupt the plotter's edge-sensing function. To remove any ink from the roller, per-
form the following procedure:
1. Connect the plotter to an ac power source.
2. Switch the plotter ON.
3. Press the Enter button on the front panel.
4. Using the arrow buttons, scroll to the
Enter button.
5. Using the arrow buttons, scroll to the
6. Simultaneously press the
menu.
7. Using the Up Arrow button, scroll to reach the following display:
8. Press the Enter button, and the following display will appear:
9. Remove any media from the plotter.
10. Raise the window. Holding the window sensor down with a pen, pencil or small
screwdriver, press the Enter button. The display will show that the arrow buttons
can be used to control the roller speed for cleaning. Press the
eral times until the drive roller reaches a convenient speed for cleaning.
The drive roller cleaning procedure should be
performed only by service-trained personnel;
otherwise personal injury may occur.
utilities menu display, then press the
statistics submenu display.
Enter and the Up Arrow buttons to access the
SERVICE TESTS
X motion control
REMOVE MEDIA
PRESS ENTER
service tests
Up Arrow button sev-
Preventive Maintenance 4-3