Operating Band Selection - Icom IC-E92D Instruction Manual

4
FREQUENCY AND CHANNEL SETTING
D Call/TV* channels
Call channels are used for quick recall of most-often used
frequencies.
* Appears only when TV channels are programmed via the
optional RS-92. Also available for A band operation only.
q Push [CALL] several times to select call channels/TV
channels (A band only).
• Call/TV channels can be selected in sequence.
w Rotate [DIAL] to select the desired channel.
[DIAL]
CALL
RX CS
16
• Call channel indication
+DUP +DUP DTCS DTCS
FM FM PRIO WX PRIO WX EMR EMR
14 145 000 000
A
MemoName MemoName
P SKIP SKIP
µ C0 C0
LOW LOW
ATT ATT
• TV channel indication
+DUP +DUP DTCS DTCS
C
WFM WFM PRIO WX PRIO WX EMR EMR
10 ch ch
25 25
A
MemoName MemoName
P SKIP SKIP
µ TV TV
LOW LOW
ATT ATT

■ Operating band selection

The transceiver can receive the AM broadcast, HF bands,
50 MHz, FM broadcast, VHF air, 144 MHz, 300 MHz, 400
MHz or 800 MHz bands.
(Some bands are not selectable for B
band operation. See next page for details.
➥ In VFO mode, push [BAND] several times to select the
desired frequency band.
• If VFO mode is not selected, such as a memory channel/call
channel/TV channel, push [VFO] to select VFO mode fi rst, then
push [BAND] to select the desired band.
➥ While pushing and holding [BAND], rotating [DIAL] also
selects the frequency band.
[DIAL]
D
BAND
)
+DUP +DUP DTCS DTCS
FM FM PRIO PRIO WX WX EMR EMR
14 144 000 000
A
MemoName MemoName
PSKIP PSKIP
µ 000 000
LOW LOW
ATT ATT