Security Setup - Kenwood DNX7140 Instruction Manual

1
Setup Menu
Security Setup
You can set a security code to protect your
receiver system against theft.
bA
~
• When the Security Code function is activated, the code
cannot be changed and the function cannot be released.
Note the Security Code can be set as the 4 digit number
of your choice.
D
Display the Security screen
Touch [0]
>
[~]
>
[System]
>
[Security).
(page 63)
D
Setup the SI (Security Indicator)
[Security Code Set] Displays the Security code
input screen.
[51] Turns the SI function on or off
If turned "ON", the SI indicator on the front
panel flashes when the vehicle ignition is off
([2]
"ON")
D
Start Security Code setup
Security Code Set
51 5
b
-ON~FF
bA
~
• If you have already completed the code registration,
[CLR] is displayed.
II
Enter a security Code
Input four-digit number
IJ
Register your security code
1 : 9
iJ
68 ONX7140/0NX7000EX/OOX714/00X7034BT
D
Reenter the security code
Reenter the same security code as that you have
entered in Step 4 for confirmation.
bA
~
• If you enter a different security code, the screen
returns to Step 4 (for the first code entry).
D
Register the security code again
" 7 ~ """8" ~
9 "£nte';
"""'0" ""
Now, your security code is registered.
If
you have pressed the Reset button
or
if you
have disconnected the Receiver from battery...
D
Enter the correct security code
You must enter the same security code as that
you have entered in Step 4.
D
Register your security code
1 : 9
iJ
Now, you can use your Receiver