Kenwood DNX7140 Instruction Manual page 109

Connection
Jf\
If you connect the ignition wire (red) and the battery
~wire
(yellow) to the car chassis (ground), you may
cause a short circuit, that in turn may start a fire. Always
connect those wires to the power source running
through the fuse box.
Ignition key
switch
t>-+;....;..AC::..:C,-,-
A
B
A+-
Ignition wire (Red)
Car fuse box
Car fuse box
(Main fuse)
B+-
C+-
Battery wire (Yellow)
Ground wire (Black)
8
(To car chassis)
( a
8=+1
1):=
Antenna Cord FM/AM
antenna input
Parking sensor wire (Light Green)
Reverse sensor wire (PurplelWhite)
For the sake of safety, be sure to connect the parking sensor.
' - - - - - '
Connect to vehicle's reverse lamp harness when
using the optional rear view camera.
~
Connect to the vehicle's parking brake
~ detection switch harness.
~
~
To steering remote
To use the steering wheel remote control feature, you need to
an exclusive remote adapter (not supplied) matches your car is
required. When this terminal is not in use, leave its cap on.
,.. Steering remote control input (Light BluelYellow)
To car light control switch
: Dimmer control wire (OrangelWhite)
Connect to the terminal that is grounded when either
the telephone rings or during conversation.
~ To connect the Kenwood navigation system,
~
consult your navigation manual.
: Mute wire (Brown)
Depending on what antenna you are using,
connect either to he control terminal of the motor antenna, or to the
power terminal for the booster amplifier of the film-type antenna.
When using the optional power amplifier,
connect to its power control terminal.
: Motor antenna control wire (Blue)
: Power control wire (BluelWhite)
~
If no connections are made, do not let the cable come out from the tab.
4
I
DNX7140/DNX7000EX/DDX714/DDX7034BT