Adjusting The Lcd Display; Specifications - Sony RCP-920 Operation Manual

Adjusting the LCD
Display
The RCP-920/921 is provided with LCD-display
adjustment mode, which permits you to adjust the
brightness and contrast of the LCD display of the paint
control block.
To enter LCD-display adjustment mode
While holding down the PARA and MASTER buttons,
press the ENTER button on the paint control block.
The LCD display shows the following:
To adjust the LCD display
Turn the paint controls (rotary encoders). You can adjust
the brightness with the left control and the contrast with
the right control.
To release LCD-display adjustment mode
Press the PARA and MASTER buttons simultaneously.
The menu display before entering the LCD-display
adjustment mode reappears.
Note
The values set in LCD-display adjustment mode are stored
in memory when the modes are canceled. Be sure to
release the modes before turning OFF the power.
76
Adjusting the LCD Display / Specifications

Specifications

General
Power requirements 10.5 to 30 V DC
Power consumption 4 W max.
Maximum cable length
200 m (656 ft) (with CCA-5 cable
connection)
Operating temperature
5 °C to 40 °C (41 °F to 104 °F)
Dimensions (w/h/d, excluding projections)
RCP-920/921: 102 × 310 × 67 mm
(4 1/8 × 12 1/4 × 2 3/4 in)
Dimensions (w/h/d, including projections)
RCP-920: 102×310×125 mm
(4 1/8 × 12 1/4 × 5 in)
RCP-921: 102 × 310 × 84 mm
(4 1/8 × 12 1/4 × 3 3/8 in)
Mass 1.8 kg (3 lb 15 oz)
Inputs/outputs
REMOTE
8-pin RJ-45 connector
CCU/CNU 8-pin multiconnector, female (1)
AUX 8-pin multiconnector, female (1)
EXT I/O 10-pin, male (1)
Supplied accessories
Operation Manual (1)
Optional accessories
External I/O connector
HIROSE HR10A-10PA-10S (74)
1-566-437-12
CCA-5-3 remote cable (3 m)
CCA-5-10 remote cable (10 m)
CCA-5-30 remote cable (30 m)
Design and specifications are subject to change without
notice.
Note
Always verify that the unit is operating properly before
use. SONY WILL NOT BE LIABLE FOR DAMAGES
OF ANY KIND INCLUDING, BUT NOT LIMITED
TO, COMPENSATION OR REIMBURSEMENT ON
ACCOUNT OF THE LOSS OF PRESENT OR
PROSPECTIVE PROFITS DUE TO FAILURE OF
THIS UNIT, EITHER DURING THE WARRANTY
PERIOD OR AFTER EXPIRATION OF THE
WARRANTY, OR FOR ANY OTHER REASON
WHATSOEVER.