Connector Panel - Sony RCP-920 Operation Manual

Parts 1 through 0 have the same function as shown for
the RCP-920.
k IRIS control
When the AUTO button is out, you can adjust the iris
manually by turning the control.
When the AUTO button is lit, the reference value for
automatic iris adjustment can be set in a range of ±1F with
this control.
See the table "Iris adjustment functions" (page 54).
l Iris gauge
The white line on the gauge provides a click position for
the IRIS control. Turn the gauge to set the line to the most
frequently used iris position, and it can be used as the
reference for manual iris adjustment.
The gauge rotates infinitely in either direction. When no
click position is required, set the line outside the rotation
range of the IRIS control.
m MASTER BLACK control knob
Manually adjust the master black level.
The setting is displayed on the MASTER BLACK display.

Connector Panel

d EXT I/O connector
c AUX REMOTE connector
b CCU/CNU REMOTE connector
a
(network) connector
a
(network) connector (8-pin RJ-45)
Used for establishing an Ethernet connection.
Connect to the network (10BASE-T/100BASE-TX) hub
using a network cable (shielded type with Category 5 and
higher). Through this connector, you can receive power
from devices, such as hubs supporting PoE, that are
compatible with IEEE802.3af standard.
CAUTION
For safety, do not connect the connector for peripheral
device wiring that might have excessive voltage to this
port.
Follow the instructions for this port.
ATTENTION
Par mesure de sécurité, ne raccordez pas le connecteur
pour le câblage de périphériques pouvant avoir une tension
excessive à ce port.
Suivez les instructions pour ce port.
ACHTUNG
Aus Sicherheitsgründen nicht mit einem Peripheriegerät-
Anschluss verbinden, der zu starke Spannung für diese
Buchse haben könnte.
Folgen Sie den Anweisungen für diese Buchse.
b CCU/CNU REMOTE (camera control unit/camera
command network unit remote) connector (8-pin
multiconnector, female)
Connects to the RCP/CNU connector of the camera
control unit or the RCP connector of the camera command
network unit.
c AUX REMOTE (auxiliary remote) connector (8-pin
multiconnector, female)
Connects to the RCP-700/701.
Note
The AUX REMOTE connector supplies power to the
remote control panel (RCP). Do not connect anything
other than the RCP to this connector.
d EXT I/O connector (10-pin, male)
Supplies preview signals.
55
Location and Function of Parts