Vermont Castings Encore Flexburn 2040 Homeowner's Installation And Operating Manual page 18

Encore ® FlexBurn ™ 2040 Non-Catalytic / Catalytic Woodburning Stove
adjust the leg levellers
Lift the stove slightly so there is no weight on the leg while
making the adjustment.
Reverse the Flue collar (if necessary)
Reverse the flue collar by removing the two screws that
attach it to the back of the stove. Be sure the gasket around
the flue collar opening is in position when you screw the
collar back onto the stove.
attach Flue collar heat Shield
waRNiNg: The flue collar heat shield must be attached
to the Encore stove. Use four #10 sheet metal screws
supplied to secure the flue collar heat shield to the rear of
the stove. (Fig. 23)
Sheet
Metal
Screws
Flue Collar
Heat Shield
Fig. 23 Install flue collar heat shield.
waRNiNg: The flue collar heat shield must be installed
in all vertical installations. The flue collar heat shield is not
used when the flue collar is in the rear exit position.
attach the Damper handle
Use the 1/4" -20 x 3" screw to attach the damper handle
to the damper stub on the left side.
attach the primary air Thermostat handle
The primary air thermostat handle is the smaller of the
two black handles. Secure the handle to the stub on the
right side of the stove with an 8-32 x 2" slot head machine
screw. (Fig. 24)
18
Sheet
Metal
Screws
ST1180
ST1180
flue collar heat shield
Fig. 24 Attach the thermostat handle.
assemble the Removable insert handle
ST635
The ceramic removable insert handle opens and closes
Encore
the front doors. Remove after each use, and store it in
Install thermostat
the handle holder behind the right front leg. Assemble
handle
the handle by passing the 3³\₈" screw through the ceramic
2/01
shaft and into the bright metal nub. (Fig. 25) Tighten care-
fully until snug.
Fig. 25 Assemble the front door handle.
ST540
Assembly
handle
11/00
ST635
ST540
30005295